Ultrasonic spray coating of polyethylenimine (ethoxylated) as electron injection and transport layer for organic light emitting diodes: The influence of layer morphology and thickness on the interface physics between polyethylenimine (ethoxylated) and the Al cathode

Abstract

Modern lighting is expected to be light weight, flexible, efficient, non-expensive and environmentally friendly fabricated. Organic light emitting diodes (OLEDs) meet all these requirements and can be manufactured using inexpensive and roll-to-roll compatible printing techniques. They, however, often use low work function, highly reactive metals, such as barium and calcium to facilitate electron injection, deposited using expensive and non-continuous vacuum techniques. Efficient and stable alternatives can be found in the aliphatic amines, polyethylenimine (PEI) and polyethylenimine(ethoxylated) (PEIE), that shift the work function of aluminum favorably for electron injection. This work demonstrates ultrasonic spray coating of PEI(E) as electron injection and transport layer for OLEDs, reducing the work function of the aluminum cathode by 0.355 eV allowing a luminous efficacy comparable to that of the OLEDs using calcium/aluminum electrodes. Slightly higher luminous results are noted for the OLEDs with spin coated PEI(E), indicating that the surface morphology and thickness of the PEI(E) layer are crucial factors: ultrasonic spray coated PEI(E) layers have an increased overall thickness and surface roughness. This study shows the potential of ultrasonic spray coating and the suitability of PEI(E) as excellent electron injection and transport layer for OLEDs and paves the way towards fully spray coated OLEDs. K E Y W O R D S electron injection and transport layer, organic light emitting diodes, printing techniques, ultrasonic spray coating This is an open access article under the terms of the Creative Commons Attribution License, which permits use, distribution and reproduction in any medium, provided the original work is properly cited.